Microsoft Robotics Studio

[ThaiVu]

Hi everyone,
I am learning to use VPL for my robotic projects. I am using Lego NXT mindstorms as a prototype. This is a new robotic platform with powerful features like text to speech, Voip, webcam, etc.
I would like you to share with me your interest, experience and ambition on this new subject.
It will be a lot fun and headache and a sense of success. Post or email me :
thaihungvu@msn.com
Thanks,
ThaiVu

[ThaiVu]

Nguyên văn bởi ThaiVu

Hi everyone,
I am learning to use VPL for my robotic projects. I am using Lego NXT mindstorms as a prototype. This is a new robotic platform with powerful features like text to speech, Voip, webcam, etc.
I would like you to share with me your interest, experience and ambition on this new subject.
It will be a lot fun and headache and a sense of success. Post or email me :
thaihungvu@msn.com
Thanks,
TV

My first lesson:
http://www.skyvu.net/thai/VPL_CountToTen.wmv

[Vinh3i]

Nguyên văn bởi ThaiVu

My first lesson:
http://www.skyvu.net/thai/VPL_CountToTen.wmv

How can I try this program?

[ThaiVu]

Nguyên văn bởi Vinh3i

How can I try this program?

Dear Vinh3i,

Goto Microsoft Robotics page, download version 1.5 then open VPL platform and start the program, using mouse to drag and drop the Activities, Services just like I did . At the end you can hit RUN on the main menu.
Try it. This is a new concept of programming for robots.
Let me know if you get into any problem.
Good luck
ThaiVu

[falleaf]

@ThaiVu: Pls write in English. If you cannot write in English, pls do not open your problem in English forum.

Have fun.

[ThaiVu]

Hi,
This is my robotic lab #2, using NXT robot and its Ultra sonic Sensor:

http://www.skyvu.net/thai/LegoNXT_LightOn.wmv

Bye

[ThaiVu]

Hi,
I am back with my MickeyMouse Robot. By using ElectroMagneticForce (EMF) sensors and RFID reader Mickey could bring food to an assigned table. I will use Microsoft VPL to communicate him thru bluetooth, Speech Rec. and Text to Speech Actitvities. So far no luck.
Thanks
ThaiVu

[falleaf]

It's quite nice, keep working on it.

[toucheco]

Hi Thai Vu and everyones
Did u work with CoroBot .
Im making this Robot.But I dont have modul SSC-32Board and PhidGets 8/8/8 Interface Kit
and Driver for them.
Can u give me how to get them or make them.
Thank lots.

[toucheco]

Hi ThaiVu!
I'm trying basically to design the robot using MRS, but i dont known to figure out, and how to communicate it with Bluetooth,Wifi, and how to program for the on-board processor.
Thanks !